CCNA 3 Ver 6.0 – OSPF Practice Skills Assessment

OSPF Practice Skills Assessment - Packet Tracer CCNA Routing and Switching - Scaling Networks Network Diagram: Diagram uses slightly different naming convention (Hostnames and vlan names) ,...

CCNA 3 Ver 6.0 – EIGRP Scan Practice Skills PT Assessment Packet Tracer

CCNA Routing and Switchingz Scaling Networks Practice Skills Assessment - EIGRP A few things to keep in mind while completing this activity: 1. Do not use the...

CCNA 3 Scaling Networks Ver 6.0 – ITN Final Exam Answers

A network administrator is adding a new VLAN for testing. The company uses VTP and the VLAN is not directly attached to either of...

CCNA 3 Scaling Networks Ver 6.0 – ITN Practice Final Exam Answers

Refer to the exhibit. A network administrator is configuring PVST+ for the three switches. What will be a result of entering these commands? S1...
CCNA3_Ch8_11

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 9 Exam Answers

Which characteristic describes both ABRs and ASBRs that are implemented in a multiarea OSPF network? They are required to reload frequently...
CCNA3_Ch8_11

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 8 Exam Answers

Which three addresses could be used as the destination address for OSPFv3 messages? (Choose three.) FF02::A FF02::1:2 2001:db8:cafe::1 FE80::1* FF02::6* FF02::5* Fill in the blank. OSPF...
CCNA3_Ch6_02

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 7 Exam Answers

Refer to the exhibit. After the configuration shown is applied on router R1, the exhibited status message is displayed. Router R1 is unable to...
CCNA3_Ch6_01

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 6 Exam Answers

What information does EIGRP maintain within the routing table? only successors* all routes known to the router only feasible successors both successors and feasible...
i212860v1n1_212860

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 5 Exam Answers

A network administrator is researching routing protocols for implementation in a critical network infrastructure. Which protocol uses the DUAL algorithm to provide almost instantaneous...
CCNA3_Ch3_02

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 4 Exam Answers

What is the purpose of HSRP? It provides a continuous network connection when a router fails.* It prevents a rogue switch from becoming...

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 3 Exam Answers

Which two network design features require Spanning Tree Protocol (STP) to ensure correct network operation? (Choose two.) redundant links between Layer 2 switches* link-state...
CCNA3_Ch3_02

CCNA 3 Scaling Networks Ver 6.0 – ITN Chapter 2 Exam Answers

Where is the vlan.dat file stored on a switch? on the externally attached storage media or internal hard drive in RAM in NVRAM in...