CCNA 2 Final Exam Answers 1 Refer to the exhibit. Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves H1, how many times is the L2 header rewritten in the path to H3? 1 2* 3 4 5 6 2 Refer to the exhibit. Which highlighted value represents a specific destination network in the routing table? 0.0.0.0 172.16.100.128* 172.16.100.2 110 791 3 On which two routers would a default static route be configured? (Choose two.) stub router connection to the rest of the corporate or campus network * any router where…
Author: adminccna
CCNA 2 Final Exam Answers 1 Refer to the exhibit. Host A has sent a packet to host B. What will be the source MAC and IP addresses on the packet when it arrives at host B? Source MAC: 00E0.FE91.7799 Source IP: 192.168.1.1 Source MAC: 00E0.FE10.17A3 Source IP: 10.1.1.10 Source MAC: 00E0.FE91.7799 Source IP: 10.1.1.10* Source MAC: 00E0.FE10.17A3 Source IP: 192.168.1.1 Source MAC: 00E0.FE91.7799 Source IP: 10.1.1.1 2 What is the effect of configuring the ipv6 unicast-routing command on a router? to assign the router to the all-nodes multicast group to enable the router as an IPv6 router* to permit…
CCNA 2 Final Exam Answers 1 Refer to the exhibit. Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves H1, how many times is the L2 header rewritten in the path to H2? 1 2* 3 4 5 6 2 Refer to the exhibit. Which highlighted value represents a specific destination network in the routing table? 0.0.0.0 172.16.100.64* 172.16.100.2 110 791 3 Which type of static route is configured with a greater administrative distance to provide a backup route to a route learned from a dynamic routing protocol? standard static…
CCNA 2 Chapter 4 Exam Answers 1 A ping fails when performed from router R1 to directly connected router R2. The network administrator then proceeds to issue the show cdp neighbors command. Why would the network administrator issue this command if the ping failed between the two routers? The network administrator suspects a virus because the ping command did not work. The network administrator wants to verify Layer 2 connectivity.* The network administrator wants to verify the IP address configured on router R2. The network administrator wants to determine if connectivity can be established from a non-directly connected network. 2…
CCNA 2 Chapter 9 Exam Answers 1 What is the primary purpose of NAT? conserve IPv4 addresses* increase network security allow peer-to-peer file sharing enhance network performance 2 Which method is used by a PAT-enabled router to send incoming packets to the correct inside hosts? It uses the destination TCP or UDP port number on the incoming packet* It uses the source TCP or UDP port number on the incoming packet It uses the source IP address on the incoming packet It uses a combination of the source TCP or UDP port number and the destination IP address on the…
CCNA 2 Chapter 8 Exam Answers 1. Which DHCPv4 message will a client send to accept an IPv4 address that is offered by a DHCP server? unicast DHCPACK broadcast DHCPACK unicast DHCPREQUEST broadcast DHCPREQUEST* 2. A company uses DHCP servers to dynamically assign IPv4 addresses to employee workstations. The address lease duration is set as 5 days. An employee returns to the office after an absence of one week. When the employee boots the workstation, it sends a message to obtain an IP address. Which Layer 2 and Layer 3 destination addresses will the message contain? FF-FF-FF-FF-FF-FF and 255.255.255.255* both…
CCNA 2 Chapter 7 Exam Answers 1 In which configuration would an outbound ACL placement be preferred over an inbound ACL placement? when the ACL is applied to an outbound interface to filter packets coming from multiple inbound interfaces before the packets exit the interfac when a router has more than one ACL when an outbound ACL is closer to the source of the traffic flow when an interface is filtered by an outbound ACL and the network attached to the interface is the source network being filtered within the ACL 2 Which address is required in the command syntax…
CCNA 2 Chapter 6 Exam Answers 1 What are three primary benefits of using VLANs? (Choose three.) security a reduction in the number of trunk links cost reduction end user satisfaction improved IT staff efficiency no required configuration 2 Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port? data default native management 3 A network administrator is determining the best placement of VLAN trunk links. Which two types of point-to-point connections utilize VLAN trunking? (Choose two.) between two switches that utilize multiple VLANs between a switch and a client PC between a…
CCNA 2 Chapter 5 Exam Answers 1. Which statement describes the port speed LED on the Cisco Catalyst 2960 switch? If the LED is green, the port is operating at 100 Mb/s. If the LED is off, the port is not operating. If the LED is blinking green, the port is operating at 10 Mb/s. If the LED is amber, the port is operating at 1000 Mb/s. 2. Which command is used to set the BOOT environment variable that defines where to find the IOS image file on a switch? config-register boot system boot loader confreg 3. What is a…
CCNA 2 Chapter 4 Exam Answers 1 A network designer must provide a rationale to a customer for a design which will move an enterprise from a flat network topology to a hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.) lower bandwidth requirements reduced cost for equipment and user training easier to provide redundant links to ensure higher availability less required equipment to provide the same performance levels simpler deployment for additional switch equipment 2 What is a collapsed core in a network design? a combination of the functionality of the…
CCNA 1 Chapter 3 Exam Answers 1. Which dynamic routing protocol was developed to interconnect different Internet service providers? BGP* EIGRP OSPF RIP 2. Which routing protocol is limited to smaller network implementations because it does not accommodate growth for larger networks? OSPF RIP* EIGRP IS-IS 3. What two tasks do dynamic routing protocols perform? (Choose two.) discover hosts update and maintain routing tables* propagate host default gateways network discovery* assign IP addressing 4. When would it be more beneficial to use a dynamic routing protocol instead of static routing? in an organization with a smaller network that is not…
CCNA 2 Chapter 2 Exam Answers 1. What are two advantages of static routing over dynamic routing? (Choose two.) Static routing is more secure because it does not advertise over the network* Static routing scales well with expanding networks Static routing requires very little knowledge of the network for correct implementation Static routing uses fewer router resources than dynamic routing* Static routing is relatively easy to configure for large networks 2. Refer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth…