CCNA 2 Module 1 Answers

CCNA Exploration 2 Chapter 1 Exam Answers

1.

CCNAExploration1Chapter1ExamAnswers thumb CCNA Exploration 2 Chapter 1 Exam Answers

Refer to the exhibit. Host A pings host B. When R4 accepts the ping into the Ethernet interface, what two pieces of header information are included? (Choose two.)

source IP address: 192.168.10.129

source IP address: BBBB.3333.5677

destination IP address: 192.168.10.33

destination IP address: 192.168.10.134

destination MAC address: 9999.DADC.1234

 

2. Which of the following is the correct flow of routines for a router startup?

load bootstrap, load IOS, apply configuration

load bootstrap, apply configuration, load IOS

load IOS, load bootstrap, apply configuration, check hardware

check hardware, apply configuration, load bootstrap, load IOS

 

3.

CCNAExploration1Module1ExamAnswers thumb CCNA Exploration 2 Chapter 1 Exam Answers

Refer to the exhibit. What can be concluded from the routing table output in the exhibit? (Choose two.)

This router only has two interfaces.

The router interfaces are not operational yet.

This router is configured to forward packets to remote networks.

The FastEthernet0/0 and Serial0/0/0 interfaces of this router were configured with an IP address and the no shutdown command.

An IP packet received by this router with a destination address of 198.18.9.1 will be forwarded out of the Serial0/0/0 interface.

(more…)

Tags: Which three commands will change the current configuration mode of a router? (Choose three ), Refer to the exhibit When all of the commands that are shown in the exhibit are entered at the correct router prompt what is the name of the router?, Refer to the exhibit Which command should be issued to configure the address of the router interface that is attached to this computer?, Which three commands will change the current configuration mode of a router?, Refer to the exhibit A network administrator is using two routers to test a WAN connection What can be concluded based on the output of the show running-config commands?, What header address information does a router change in the information it receives from an attached Ethernet interface before information is transmitted out another interface?, Which three commands will change the current configuration mode of a router, which three commands will change the current configuration mode of a router (choose three ), ccna exploration routing protocols and concepts (version 4 0) chapter 1, Which two locations can be the source of the Cisco IOS that is used by a router during the bootup process? (Choose two ), Which two statements correctly describe the components of a router? (Choose two ), Refer to the exhibit What can be concluded from the output of the running-configuration of a router?, From what location can a router load the Cisco IOS during the boot process? (Choose two ), Which command should be issued to configure the address of the router interface that is attached to this computer?, CCNA Exploration 2 Chapter 1 Exam Answers, The network administrator needs to connect two routers directly via their FastEthernet ports What cable should the network administrator use?, ccna exploration routing protocols and concepts (version 4 0) chapter 1 answers, Which are functions of a router? (Choose three ), A network administrator has just entered new configurations into Router1 Which command should be executed to save configuration changes to NVRAM?, ccna exploration 2 chapter 1 answers, What is the default sequence for loading the configuration file?, From what location can a router load the Cisco IOS during the boot process?, What are the source and destination file locations when the R1# copy startup-config tftp command is executed?, Refer to the exhibit Which command should be issued to configure the address of the router interface that is attached to this computer, Which interfaces in the exhibit could be used for a leased line WAN connection? (Choose two ), exploration 2 chapter 1, which two pieces of information can an administrator verify by using the show version command? (choose two ), Which two locations can be the source of the Cisco IOS that is used by a router during the bootup process?, A network administrator is using two routers to test a WAN connection What can be concluded based on the output of the show running-config commands?, When all of the commands that are shown in the exhibit are entered at the correct router prompt what is the name of the router, Which three commands will change the current configuration mode of a router? (Choose three, from what location can a router load the cisco ios during the boot process, Refer to the exhibit A network administrator is using two routers to test a WAN connection What can be concluded based on the output of the show running-config commands, cisco Exploration 2 chapter 1 answers, Cisco Exploration 2 chapter 1, What can a network administrator modify on a router to specify the location from which the Cisco IOS loads? (Choose two ), What is the default sequence for loading the configuration file, passwords can be used to restrict access to all or parts of the cisco ios select the modes and interfaces that can be protected with passwords (choose three ), Refer to the exhibit Host A pings host B When R4 accepts the ping into the Ethernet interface what two pieces of header information are included?, Which two statements correctly describe the components of a router, Refer to the exhibit All routers have a route in its routing table to each network that is shown in the exhibit Default routes have not been issued on these routers What can be concluded about how packets are forwarded in this network? (Choose two ), Which two locations can be the source of the Cisco IOS that is used by a router during the bootup process, Which three commands will change the current configuration mode of a router choose three, Which two statements correctly describe the components of a router?, What three processes does a router execute when it receives a packet from one network that is destined for another network? (Choose three ), What are two functions of a router? (Choose two ), chapter 1 ccna exploration routing protocols and concepts version 4 0 answers, Refer to the exhibit The frame shown in the exhibit was received by the router The router interfaces are operational How will the router process this frame? (Choose two ), What header address information does a router change in the information it receives from an attached Ethernet interface before information is transmitted out another interface, ccna exploration routing protocols and concepts (version 4 0) answers chapter 1